How to clean the sieve holes of corn processing equipment

 In the production of corn processing equipment, the screen is mainly used to clean up impurities and a configuration for layered screening of materials, because the size of the material particles contained in it is unavoidable, so some materials will be directly left on the screen. In the hole, workers need to clean up in time to avoid clogging and affecting production. But how should the sieve holes of the corn processing machinery be cleaned?

       Cleaning the corn processing equipment is not an easy task. There will inevitably be various scattered grains in the corners of the equipment. These scattered grains will attract many small bugs and affect the use of the equipment. The mixing of wheat, flour and dust makes it difficult to meet product hygiene standards, and it is troublesome to clean up impurities.

       If there are impurities in the product processing, it is usually caused by the damage of the cleaning screen, which should be adjusted or replaced in time. If the corn raw material is broken too much, it will also cause the product quality to be unqualified, and it is also caused by the excessively large cleaning sieve. In order to improve the processing efficiency, the daily cleaning of the screen holes is inevitable.

      The common reasons for the clogging of the corn processing sieve are the wrong rotation of the main shaft of the corn processing equipment, the sealing of the sieve frame or the broken sieve. In response to this situation, the installation and settings of the corn processing equipment should be checked, the wear and tear of various parts should be checked, and replaced and repaired in time.