Several situations often appearing in the production of buckwheat processing machinery

Several situations often appearing in the production of buckwheat processing machinery

In the production of buckwheat machinery, there will be some situations in the production due to the operation or some objective influences, which will affect the normal production.

Today, the editor has counted some common and new situations in the production of buckwheat machinery for your reference.

The current buckwheat planting method is relatively scattered, so the quality of the collected buckwheat varies, especially some buckwheat will be mixed with a lot of impurities, or the buckwheat grains are damaged. The selection is done when the buckwheat is selected.

There may also be mechanical clogging caused by buckwheat being too wet. Therefore, you should pay attention to all aspects of the buckwheat deepening, to avoid some minor problems affecting the normal work.

With the continuous extension of the use time of buckwheat machinery and equipment, the grinding teeth gradually wear out, and the moving speed of the material in the grinding area will be reduced. And because the height of the grinding teeth is reduced, the material in the gap between the two grinding teeth is reduced and the output is gradually reduced.

Manufacturers use buckwheat machinery and equipment to produce a variety of buckwheat foods, such as buckwheat noodles, buckwheat flour and other buckwheat foods. Now the machinery and equipment produced by buckwheat equipment manufacturers are fully functional and can meet the requirements of manufacturers.