What problems should be paid attention to in the use of corn mill

The corn mill is a device often used in rural households. It can process mature corn kernels into corn flour for people to eat in their lives, which is very convenient.

　　 We know that the traditional way of milling corn is to use a stone mill, not to mention laborious, the milling time is long, and it takes a little bit of effort to grind it out. The corn flour mill uses electricity to drive the equipment. When the machine is powered on, the equipment runs. It is very convenient to pour the corn kernels into the corn flour, and the grain size of the corn flour can be controlled through a screen, which is very convenient.

　　 The use of corn milling machine should pay attention to the following issues:

　　①The uniformity of grinding particles. When the particle size of the material entering the same grinding system is very different, some smaller particles will not be affected by the grinding effect, so that the output will be affected. If you want to avoid it, you should try to reduce this gap to ensure uniformity.

　　②The capacity of grinding material. After the corn is ground one by one, the endosperm is gradually scraped off. As the number of skin grinding passes is pushed back, the bulk density of the material is reduced, and the unit flow rate of the corn processing equipment is also reduced. It can be seen that it is very important to learn to control the amount of raw materials added.

　　③The height of grinding teeth. In the grinding process, as the grinding teeth gradually wear, it is difficult for the grinding teeth to grasp the material, and the sliding on the surface of the grinding roller increases, the material in the gap between the two grinding teeth decreases, and the output will gradually decrease. At this time, pay attention to timely replacement or adjustment.

　　④ Adjust the degree of crushing of materials. When operating the equipment, as the rolling distance decreases, the length of the grinding area increases. At this time, the number of teeth of the fast roller on the material increases, and the degree of pulverization increases.